MB100 USB to RS485 Interface
Data Sheet
• connects RS-485 to computer
• no driver software to install
• powered over the USB
• used to program Microva devices
• connects Microva software to Modbus
real time control systems, Modbus RTU devices, low cost I2C I/O modules, free BASIC compiler software, motor controllers, controllers with color graphic displays
• connects RS-485 to computer
• no driver software to install
• powered over the USB
• used to program Microva devices
• connects Microva software to Modbus
• sealed lead acid battery backup power
• monitors and charges the battery
• prevents battery over charge or discharge
• read battery status/voltage on Modbus RTU
• external LEDs indicate battery status
• connect RS-485 to ribbon cable
• breakout board- no circuitry
• removeable terminal plug
• fits with Microva Modbus RTU modules
• connects serial device to computer
• no driver software to install
• powered over the USB
• used to program Microva MB160
• common SMT layouts, see data sheet
• hand solder SMT devices for protos
• 30 small PCBs separated by hand
• 0.1 inch pitch holes for pin headers
• SMT pads on both sides
• six tactile switch inputs
• connects to Microva MX port
• low cost gaming keypad
• no active circuitry
• requires eight pin ribbon cable
• accurate position sensor
• slotted infrared LED detector
• open drain output
• wide power supply range
• includes mounting hardware
Microva Corporation
220 N Main St Unit A
Sellersville, PA 18960
sales support: sales@microva.com
tech support: support@microva.com
© Microva Corporation. All rights reserved.